Traffic Light Controller Using Arduino In Proteus

Published on nov 8 2018 in this video you are going to see the simulation of an automatic traffic light controller using 8051 microcontrollers in proteus software.

Traffic light controller using arduino in proteus.

We have covered a more simpler version of traffic lights in this traffic light circuit. Traffic light using 555 timer ic in proteus. These can be applied at high traffic areas to avoid traffic blocks or accidents. The working of the project is very simple and is explained below.

Here have demonstrated it for 3 sides or ways. The aim of the project is to implement a simple traffic light controller using arduino uno where the traffic is controlled in a pre defined timing system. Its quite a simple project so the circuit is quite simple as well. It uses code as an internal timer and continues to run until you cut the arduino s power supply.

Arduino software and library. And the source code used in. Consider the following gif image showing a loop of traffic light operations. First of all design a circuit in proteus for traffic signal control using arduino as shown in the below figure.

Components we need is. This traffic light controller will be used to control the flow of traffic. In this video i am showing you how to make traffic lights using proteus simulator. This arduino based 3 way traffic light controller is a simple arduino diy project which is useful to understand the working of traffic lights which we see around us.

The main part of this project is the arduino which will control the leds and their timings to guide the vehicles. Like subscribe and share. You can see i have just placed an arduino board and plugged three leds with it and obviously they are green yellow and red in color. Links to buy components.