Stretch the carpet with the knee kicker to link to the hooks in the binder bar then use a wooden block or scrap piece of lumber to close the binder bar onto the edge of the carpet.
Tools needed to install wall to wall carpet.
Carpet knee kickers by roberts a4716.
Probably one of the most essential tools for carpet installation is the stretcher.
Bent on one end to engage the end of the laminate and bent on the other end to allow a mallet or hammer to strike and drive the tool a pull bar is an essential tool for a successful laminate installation.
Use the binder bar.
Carpet tiles which can be either glue down or peel and stick.
Glue down carpet tiles require manually spreading an adhesive to the subfloor and are often used in commercial buildings.
These 12 tools are essential to get any carpet install professionally installed via the tack strip method.
Use a wall trimmer to make straight cuts in carpet along a wall.
In preparation for installing carpet tiles you will need the following tools and materials.
Staplers electric staple guns and hammer staples shown above are used to tack carpet pad to the subfloor.
Mark used one with a tail that dug into the carpet and stretched the carpet for a great fit it almost looked like he was going to ruin the carpet with the deadly looking thing.
Remove everything from the floor and any doors that open into the room where carpet will be installed.
In addition to hooking the strips with a knee kicker on one side the other end needs a stronger tool to tightly stretch the carpet.
Nail a binder bar to any areas where the carpet ends without abutting a wall such as a threshold.
Position the strips with the tack points facing the wall.
Use a small hand saw or specially designed snips to cut carpet tack strips to fit the perimeter of the room.
Dig the teeth of the knee kicker into the carpet about 1 from the wall.
While the traxx 5418 electric stapler delivers industrial strength with superior maneuverability.
Swiftly kick the cushioned end of the knee kicker with your knee to hook the carpet to the tackless strip.
Heavy weight carpet roller.
Hook the carpet to the tackless strip starting in one of the corners.
The installation process for a wall to wall carpet involves stretching.
Another tool you can rent instead of purchasing this roller smooths out newly laid carpet.
These tools will help you to tuck in the carpet against the wall and also to get a clean crisp trimmed edge when you cut away the carpet.
Use a knee kicker to force the edges of the carpet onto the tackless strip.
Wall trimmer stair tucker.