Tool To Tuck Carpet Under Baseboard

Trim the carpet back before tucking it.

Tool to tuck carpet under baseboard.

Achieve finished wall edges with the roberts ez tuck carpet tucker. This is not a good idea and will in most cases make it tougher on the carpet layers. Cut the damaged ones into four. Position carpet underlay so its edges butt up against the tack strips but do not overlap onto the tacks.

I trust sam is using one of these tools to cut his carpet. But baseboard installation for carpet is a bit different than the norm. Position them parallel. If you re going to install baseboards before installing the floor you have to make sure you have the proper gap to allow the flooring to get tucked under the baseboards.

Reach in front of the power stretcher to hook the carpet onto the tack strip. Vacuum the bare floor thoroughly to remove all dust and dirt. Some carpenters place the trim down to the subfloor or to the wood flooring. How to install carpet under baseboards.

How to install base board trim for carpet areas. The way i was taught was to tuck under the trim and then cut it off under the trim. Baseboard installation for carpet baseboard trim installation is one thing that just anyone can do. Look through your selection of baseboard pieces for damaged ones.

Push the lever down to stretch the carpet taut. Flush cutting was a little more challenging in that you had to jam the carpet hard into the corner made by the wall trim and the floor and cut directly into the apex. Use these to make sample. Some pieces won t be straight while others may have blemishes in the wood.

This should seem obvious but well if you make the gap under the baseboards too small for the flooring to fit then a hammer and a wonder bar might be the only tools to get you to the end of your flooring install job. I use a standard carpet knife only. Continue along the wall then trim excess with the wall trimmer and tuck the edge underneath the baseboard. Use a scrap board to prevent damage to the baseboard.

Order more baseboard trim than you need. Make a point to leave about a quarter of an inch overlapping the hard surface flooring before tucking it in place. Nail carpet tack strips around the perimeter of the room.