Tongue And Groove Vinyl Flooring Installation

Lay the first plank appropriately spaced from the wall.

Tongue and groove vinyl flooring installation.

Lower the second plank to snap the planks together. This type of installation requires no tape or adhesive and creates a floating floor. Trim the short tongue edge from the first vinyl plank. You don t need a truck load of tools to do a good job installing them and once you get the hang of it you can work like a pro.

Be sure that your first board is placed with the tongue edging pointing into the room. Floating floor step 1 underlayment. Install the second plank next to the first by aligning the tongue into the groove and press the plank down to snap it in place. During installation the ridge side of one board is fitted into the groove side of an adjacent board creating a snug seam.

Step 2 begin laying the boards. B insert the short end of the second plank into the short end of the first plank as shown offset the planks by about 1 2. The short width sides of tongue and groove flooring planks also feature. Install the second plank by holding it at an angle and inserting its tongue edge into the first plank s groove edge.

1 you re usually working over your head. This allows a simple vertical movement to slide your floor boards together and into place during installation. When you come to the end of the first row cut the length of plank needed to complete the row. Tongue and groove also known as click lock vinyl is one of the simplest ways to install vinyl flooring.

Pros of tongue and groove flooring. If necessary you can apply a layer of vapor barrier to the floor and then you need to roll out. Tongue and groove flooring has a tongue side that sticks out and a receiving groove side that is indented. 2 you have to seat the tongues and grooves together and they don t always want to marry.

Lower the plank down until the joint closes. Begin the first row of flooring by placing the planks with the tongue side facing the wall. A angle the first plank at a 20 angle and insert the long side tongue into the groove edge of the first row. Step 3 apply glue and attach boards.

Each floor board can slide into place because the tongue side can slide into the groove side.